Adjusting Tension On Garage Door

Once your garage door is secured remove the spring hook from the track hanger which will allow you to move the hook and adjust the spring s tension.

Adjusting tension on garage door. Adjust the springs on both sides of the door the same way. Once the spring is free of tension remove from its track hanger. Then insert another rod into a hole below the rod you already inserted.

Adjust the dial or knob until pressing the opener causes it to stop raising the door as it becomes about even with the top of the garage door opening. If the door was closing too quickly move the spring to the next higher hole on the bracket. Move to the outside of the garage.

It will release the door opener. Disconnect the door from the automatic opener using the disconnect cord. If it was opening too quickly move it to the next lower hole.

This cone has notches in it that are used to adjust the tension in the torsion spring. Adjusting it beyond that will cause it to. To adjust your garage door s side mounted springs first open your door fully and secure it in place with a c clamp below the bottom roller.

If the door is hard to raise the tension at the hinge springs is too. To open the door completely adjust garage door opener by turning the limit counterclockwise. Retest the door.

Lower the door and use 2 metal rods to adjust the tension in the spring. Open the door fully to relieve the tension on. Get two c clamps and attach them to the door s track just beneath the roller that s.